Low cost NTC air temperature sensor with 1/8" NPT thread and Deutsch 2-way electrical connector. Uses the same calibration as Delco air temperature sensors. Suitable for use

M12x1.5 thread pitch -30 to 130°C Operating Temperature Bosch Design reliability common calibration works with most engine management Bosch LK-2 Connector.

Bosch 085 exposed wire air temperature sensor. NOTE - calibration is not the same as the Bosch 039 and 026 temperature sensors. Bosch 085 air temp sensor.

Temperature Sensor NTC M12-H Order number 0281.002.170 Dimensions Bosch Motorsport | Temperature Sensor NTC M12-H 2 | 2 Represented by: Europe: Bosch Engineering Motorsport Robert-Bosch-Allee 1 74232 Abstatt Germany Tel.: +49 7062 911 9101 Fax: +49 7062 911 79104 [email protected] www.bosch-motorsport.de North America: Bosch Engineering

30° to 140°C Temp Sensor, Mating Connector Bosch LK-2.

Air Temperature · Accessories · Bosch TMAP Aluminium Weld Flange · 1/8″ NPT Air Temp Sensor · Bosch Reluctor Sensor · Compact Flex Fuel Composition & Temperature 

Find 6 listings related to Temp Control Mechanical in Hillsboro on YP.com. See reviews, photos, directions, phone numbers and more for Temp Control Mechanical locations in Hillsboro, OR. From Business: Trust the HVAC contractors at Dons Air Care Inc. for heating and air conditioning service, repair, and installation.

This sensor is designed to measure temperatures up to 300°C of oil, water, fuel or air. This signal is used as a control value for engine control units or 

Then you need to open TunerStudioMS, and under 'Tools→Calibrate Thermistor Tables' specify the Air Temperature Sensor, then either select your sensor or enter 

The first thing you have to realize is that the PFC is hard coded to expect a certain resistance sweep from the temperature sensors (air and water temp). You can't change the calibration without doing something on the hardware level. So that means the GM Sensor is out, unless you just want to log voltages with a Datalogit. There is a chance

Trying to make the sensor work correctly. The 1kOhm resistor installed between +5V and Avi4. The calibration of the sensor the same as the GM cooliant temp sensor. Is that right? The sensor shows +15 deg, however there is air temp +30 out board. Where is mistake? JDM ST205 PS500 UZX81 project Top NihonSubaru Posts: 7